Eventide H8000FW User's Guide download pdf (Page 85)

The Harmonizer

Programmer’s Manual

Interface Modules

Control inputs are used to send a parameter value into a module. The parameter value is generated by

another module, perhaps a knob module. One common use for this capability is the creation of custom

“parameter adjusters” to adjust the parameters for the modules in a program. The custom “parameter

adjusters” are special purpose modules from the “interface” module group. This group includes the

common text/numerical parameter adjuster that is generated by the knob module, as well as several

graphical “parameter adjusters” (hfader module, vfader module, and rfader module).

PARAMETER ADJUSTERS

“Parameter adjuster” modules have a single control output and a

userobject output. If connected to a menupage module, a

“parameter adjuster” will show up on the menu page in the

PARAMETER area as a parameter.

For example, in the now infamous program

Patch Instruct

shown to the right, the module named “

delay knob” is a

“parameter adjuster."

Its userobject is connected to a menupage module. . .

. . .which is in turn connected to the head module.

Thus, the module named “delay knob” shows up in the

PARAMETER area as a parameter (Each Delay).

Selecting a parameter in the

PARAMETER area and rotating the

KNOB will change the value of the “parameter adjuster’s” control

output. The change will also be reflected in a textual or

graphical display change. In this case, rotating the KNOB

changes the

Each Delay parameter in the PARAMETER area. . .

. . .and it changes the value sent from the “

delay knob’s”

control output into both dly modules and the mul module (of

course this screen doesn’t show the change, but the value has

changed nonetheless!) .

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 98 99

No comments

Eventide H8000FW User's Guide Page 85