Eventide H8000FW User's Guide download pdf (Page 90)

The Harmonizer

Programmer’s Manual

The 8 char name is used only if this module’s userobject is

connected directly to the head module. Normally its

userobject will be connected a menupage module. Refer to

the Modules Section for complete information.

Percentknob Module

The percentknob module is very similar to the knob

module. The only difference is that the control output value is

divided by 100. Refer to the Modules Section for complete

information.

Tapknob Module

The tapknob module is a modification of the standard knob

module. Just like the knob module, the

menu statement is

used to create the 20-character text display. However, instead

of using the

%f format, the %s format is used. The tapknob

module creates an 8-character numeric result that is inserted in place of the %s.

The tapknob module creates a tapered (non-linear) control

that has a “selectable” number of steps (instead of the usual

resolution parameter) and a “selectable” taper waveform.

The greater the taper specifier, the more non-linear the

parameter response. Refer to the Modules Section for

complete information.

Rfader Module

The rfader module creates a graphic on the PARAMETER

screen. The graphic, including title, takes up four lines of the

screen and one quarter of the width of the screen. Up to four of

these modules can fit on one menu page.

Nine characters of the menu statement are displayed above the

graphic as a title. Refer to the Modules Section for complete

information.

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 98 99

No comments

Eventide H8000FW User's Guide Page 90