Eventide H8000FW User's Guide download pdf (Page 96)

The Harmonizer

Programmer’s Manual

• So that we can differentiate this menupage module from the

next one we insert, use the <modify> SOFT KEY on it and change

its name to “1menupage." Do this by selecting the name

specifier, pressing the SELECT key, turning the KNOB right until

the highlighted line reads “1menupage." and pressing the

SELECT key.

After you’ve changed the name, press the<done> SOFT KEY

and note that the module name is displayed in the upper right

corner of the screen.

• Select the aud+ctrl display mode.

• <insert> a meter module from the “Interface” group.

• Go back to the misc display mode and use the <modify>

SOFT KEY on the menupage module. (Use the LEFT or

RIGHT CURSOR key to choose the menupage module.)

• Set the # entries specifier to 1 and then set the obj1

specifier to meter-obj. Make sure you use the SELECT key

to save each change. Press the <done> SOFT KEY to exit from the <modify> menu.

• Use the <modify> SOFT KEY on the head (hed) module.

Change its # entries parameter to 1 (if it isn’t already) and set

obj1 to 1menupage-obj.

• Return to the PARAMETER area and observe the menu page.

Note that it has one meter module monitor. Note also that

the SOFT KEY is not stacked and that the menu page’s title is

“menupage."

• Go back to the Patch Editor, misc display mode and use the

<modify> SOFT KEY on the menupage module.

• Set the

# entries specifier to 2 and then set the obj2

specifier to meter-obj (same as obj1).

1 2 ... 91 92 93 94 95 96 97 98 99

No comments

Eventide H8000FW User's Guide Page 96